Xtreamer AirMouse Pro, User Manual, Page: 14 / 19

Switching o ff the AirMouse Pro
After using the AirMouse Pro, push the switch to the “OFF”
position. The USB receiver does not need to be pulled out
from the PC.
Pairing the IR Remote function
1. Press the SET of (IR Remote) more than 3 seconds - the (IR
Remote)'s light will
fl ash one time then long-time on.
2. Press SET key one time, the (IR Remote)'s LED will fl ash
slowly, it is in learning status.
3. Aim the (IR Remote)'s infrared LED at your original
remote control's infrared LED in parallel alignment (PS:
the relative distance not more than 7 cm).
4. Press Power button on original remote control, (IR
Remote)'s LED will be
fl ash for 1 second then long-time
on, it is success in learning.
5. Press the SET key one time, then release without any
operation, the device will retire from the learning state.
Pointer speed
FN + DPI: adjust the air mouse pointer speed among the three
level.
Charging the battery
The device uses built-in lithium-ion battery. Please use only
approved data cables and chargers.
Note: Fully charge the unit before initial operation. This device
can be used when charging, but charging time will be
extended.
When the battery is low, the low-voltage Red LED will blink to
warn the user. When the Red LED turns o
ff - that means the
battery charge fully.
| Xtreamer AirMouse Pro user guide 14