Xtool Laserbox Pro, Manual

Page: 29 / 37

Document copyright belongs to xTool
Bring sketch to life
What can it do?
Laserbox can identify images drawn on Makeblock materials and A4 copy paper. Based on its
identification results, Laserbox can cut/engrave those images.
By default, Laserbox engraves lines drawn in black, and cut lines drawn in red.
Go to Settings, and select the Cut outline option. Then, the laser cutter will start engraving the outlines
drawn in black.
NOTE

Use Makeblock materials. Reflective materials or materials too dark will make it much harder for Laserbox to
identify images.

Use Makeblock-recommended markers. Images printed out or too thin(<2mm) will make it much harder for
Laserbox to identify. Deli s550 marker pens are recommended.

Avoid drawing small images. Images smaller than a size of 4mm*4mm could be regarded as distractions and
thus be deleted.

Draw images at the center of materials. Images close to the edges may lead to the failure of Laserbox to
accurately position the material scope. Images near the ring code could be regarded as distractions and
deleted.

Keep black lines at a distance with red lines when drawing an image. Make sure the distance is more than
2mm.
How to use it?
1. Draw images.
On a Makeblock material or a piece of white A4 paper, use a black or red marker to draw images.
2. Put it into Laserbox.
Open the lid. Put the material horizontally at the center of the working area.