XTM DFR4020XTM Quick Start Manual Download Page 10

10

11

OWNERS MANUAL
TIPS AND SUGGESTIONS

+   When the appliance is being set at 0° or lower  
  temperatures, do not store glass bottles or liquids  
  such as beer, milk, juices or soft drinks in the unit  
  as these may freeze and shatter.
+   To improve the efficiency of your fridge  
  it is better to have the drawer as full as possible  
  at all times. A full drawer will provide lower  
  power consumption over 24 hours than a half  

 

  empty one. When the drawer is full there is  
  little air space between the goods so the cold air  
  is trapped, but when there is lots of air the  
  coldness cannot be captured and held. On a trip  
  it is a good idea to replace finished products with  
  bottles of water or similar. This will fill the empty  
  spaces and allow the coldness to remain within  
  the drawer.
+   Frequent drawer opening will allow warm air to  
  enter the drawer. Keep the number of times you  
  open the drawer to a minimum where possible.
+   When located in the rear of a car or trailer, it is  
  recommended that the appliance be kept away    
  from direct sunlight to reduce the risk of  
  increased heat. It should also be provided with  
  suitable ventilation to guarantee efficient power    
  consumption and performance. You must  
  remember that when a vehicle is parked in the sun  
  on a day where the ambient temperature is  
  +30°C, the interior of the vehicle can reach  
 +55°C.
MAINTENANCE AND SERVICE 
Your fridge will be delivered cleaned from the 
factory – you nevertheless should clean prior to 
initial use. Take a cloth which has been slightly 
moistened with lukewarm water. Pay attention that 
no water drops into the seals and possibly damages 
the electronics. Dry off the fridge with a cloth after 
cleaning. Clean your fridge periodically and as soon 
as it is dirty.
ATTENTION:
+   DO NOT use solvents or agents with sand or acid  
  parts for cleaning your fridge.
+   DO NOT use brushes, graters or hard sharp tools  
  to clean your fridge.
+   Before cleaning, the power cord should be  
  disconnected and the fridge switched OFF.

+   Clean the fridge inside and out with a damp cloth.  
  For stubborn dirt, use some sodium bicarbonate  
  dissolved in lukewarm water.
+   After washing, rinse with clean water and dry  
 carefully.
+   When storing your fridge for a long period  
  of time, DO NOT fully close the drawer. This will  
  prevent mould and odours. For additional queries,  
  service and maintenance please contact our After  
  Sales Support 1300 174 876. They will provide  
  you with expert advice on further information you  
  may require.
DISPOSAL
When it comes to the end of its working life, your 
fridge should be disposed of responsibly to ensure 
that it does not contaminate the environment. It 
would be advisable to contact your local council for 
where to recycle your fridge.

Summary of Contents for DFR4020XTM













Reviews: