XTM Racing XT2 Racer, Operation, Tuning Manual And Replacement Parts

Page: 23 / 24

Page 23
if yoU'rE HaVing a ProbLEM WiTH THE X-TErMinaTor 2 rTr 4WD niTro bUggy CHaSSiS:
ProbLEM CaUSE SoLUTion
) Nitro Buggy pulls to one side A) Steering trim out of adjustment A) Readjust trim to centre both wheels (P0)
B) Toe angle out of adjustment B) Readjust toe angle (P8)
C) One wheel is hanging or has damaged bearing C) Remove wheel and clean bearing. Replace if necessary
2) Brakes seem ineffective A) Brake linkage out of adjustment A) Readjust brake linkage (P7)
B) Brake disc(s) worn B) Replace affected brake disc(s)
3) Clutch does not engage A) Clutch shoes damaged or worn A) Replace clutch shoes
B) Clutch bell damaged or worn B) Replace clutch bell
C) Clutch shoes glazed C) Remove glaze using fine sandpaper and reinstall
4) Clutch does not disengage A) Clutch spring(s) worn or damaged A) Replace clutch springs
5) Nitro Buggy does not "go" A) Stripped or damaged spur gear A) Replace spur gear
B) Stripped differential gear(s) B) Replace differential gear(s)
C) Driveshaft(s) slipping and/or broken C) Tighten grub screw and/or replace drive shaft(s)
D) Outdrive cups slipping D) Tighten grub screw in outdrive cups
E) Clutch not engaging E) Check clutch assembly and repair or replace
G) Carburettor set too rich G) Lean high speed needle valve (P6)
6) Suspension not smooth or free A) One or more shock sticking A) Clean and/or rebuild the affected shock(s)
B) Bent shock shaft B) Rebuild affected shock
C) Bent or otherwise damaged hinge pin C) Replace hinge pin
7) Shocks leaking oil A) Shock seals worn A) Replace shock seals
B) Bent shock shaft B) Rebuild affected shock/Replace shock shaft
8) Spur gear strips out A) Gear mesh too loose A) Replace spur gear and readjust gear mesh (P2)
9) Nitro Buggy rolls while engine A) Engine idle is too high A) Lower your engine's idle speed (P2)
is idling
0) Screws loosen and/or fall A) Vibration under normal use A) Clean screw(s) and/or replace and use
out during use threadlock to secure them into place
) Steering sensitivity is A) Servo saver spring is set too loose A) Tighten servo saver spring - see below
"sluggish"
for MorE TiPS anD TroUbLESHooTing SoLUTionS, CHECK oUT THE
onLinE X-TErMinaTor 2 rTr 4WD niTro bUggy forUM aT:
WWW.TEaMXTM.CoM
If your X-Terminator 2 RTR 4WD Nitro Buggy's steering seems sluggish or slow to react, the servo
saver spring could be too loose. To increase steering response, thread the servo saver adjustment
ring up to tighten the servo saver spring.
Warning Tightening the servo saver spring increases the chance of damaging the steering
servo during a crash. Adjust only as necessary.