XTline XT130518, Original Instruction Manual

Page: 35 / 39

BATTERY INSTALLATION AND REPLACEMENT
Batteries are not included in the product. New, fully charged batteries shall be inserted before
the first start (2x AA - 1.5 V). Do not insert damaged or non-matching batteries into the device.
A) There is a plastic battery cover on the back and bottom side of the product. Open and
remove the cover carefully.
B) If the device has already been used and there are dead batteries in it, remove them first.
Otherwise, insert two pieces of suitable type of batteries following the marked polarity.
C) Place and snap the plastic battery cover back into its original place.
TIP!
•
Replace the batteries with new ones whenever you notice a decrease in the performance
of the device, a dimming, poor visibility of the beam, or if the device can no longer be
started with the main switch.
The product is already fully assembled at the factory and ready for use after inserting the suitable
type of batteries. Remove the laser device from the fabric box. The product includes a 1/4" male
thread holder and a nut. To secure the laser device onto the holder, simply place the male thread
of the holder into the female threaded hole in the laser body (3) and turn the nut clockwise until
fully tighten.
It is then possible to rotate the laser in a horizontal position in a full
360°
angle (with the exception
of a small section blocked by the body of the holder).
TIP!
•
Due to the strong magnets, the holder can be placed on any magnetic surface, or hung on
the wall through the cut-out hole, e.g., on a nail, screw or other suitable anchor element.
MAIN SWITCH (ON/OFF)
The
main switch
(1) is used to turn the laser beam on and off.
A) First, make sure that the work mode switch (2) is set to the "locked" position - see the
figure below.
B) Then press and hold the main switch button (1) for about 2 seconds.
C) The laser cross beam will light up.
D) To turn off the laser beam, press and hold the main switch button (1) for 2 seconds again.