Starting up
After connecting the pressure cleaner to your cold water supply,
proceed as follows:
-
Make sure that the ON/OFF switch is in the OFF position
-
Connect the garden hose to the inlet fitting
-
Insert the adjustable spray nozzle into the gun as per assemply step 1
-
Install the handle to the machine main body, as per assemply step 2
-
Connect the high pressure hose to the high pressure outlet fitting as per assemply step 3
-
Connect the high pressure hose to the gun, as per assemply step 4
-
Connect the gun to the specified detergent nozzle, as per assemply step 5
-
Open the watter supply valve completely.
-
Before turning the unit on, press the gun trigger to bleed all the remaining air out of the pump
and hose.
-
Start the pressure cleaner by turning the on/off switch to the on position and squeeze the
trigger.
-
Reminder: Motor does not run continuously, only when the trigger is squeezed.
Warning - RISK OF INJECTION! Unit will start spraying when trigger is squeezed. When
turning the unit off after use, high pressure still exists inside the hose and unit. Point the gun in
a safe direction and discharge the excess pressure. Never direct the high pressure water stream at
people or animals
Automatic ON/OFF
The pressure cleaner is equipped with an automatic on/off switch. The pressure cleaner will only
run when the power switch is in the ON position and the bigger on the gun is squeezed. When
you release the trigger to stop spraying water through the gun, the motor on the pressure cleaner
will automatically shut off. Simply squeeze the trigger again to resume using the cleaner, release
the trigger and switch the unit to the OFF position. The unit should be turned completely OFF
while not in use or while unattended.
Bleeding the gun
It is very important to bleed the gun before using the pressure cleaner. Refer to the "Assembly
instructions" to assemble the pressure cleaner. To bleed the gun, simply connect the garden hose
to the pressure cleaner and squeeze the trigger before turning the electrical supply on. This
allows any air trapped inside the pressure cleaner and gun to be removed before using the unit.
Continue holding trigger for approximately one minute to allow any excess air out of the unit.
Water will flow through the gun at low pressure during this procedure. For more bleeding tips,
see the section titled "Operating instructions".
Gun safety lock
This pressure cleaner is equipped with a gun trigger safety lock. When not using the pressure
cleaner, use the safety lock to keep from accidentally angaging the high pressure spray.
Nozzle
With the adjustable nozzle, the dispersion at the water cone and the change of the shampooing /
rinsing mode can be changed. The water cone can be changed by turning the shampoo / rinse
nozzle - by inserting and extending the nozzle.
Detergents will not clog the filter and will protect the internal parts of the pressure cleaner
for a longer life
Step 1
Separate the lid from the detergent cantianer bu turning the detergent reservoir counter and
separating the two parts.
Step 2
Fill the detergebt container with approved detergent. Pour the detergent slowly into the bottle
using a funnel. Re-attach the two parts by re-inserting the lid back onto the detergent bottle and
turning clockwise. Finally, insert the pipe back in.
Step 3
Adjust the nozzle to the shampoo mode by sliding it forward. Slide back to return to the water
function.
(+)
washing water
(-)
shampooing
