XTline XT105350, Manual

Page: 37 / 43

> Use the power tool, accessories and tool bits etc., in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended
could result in a hazardous situation.
5.SERVICE
> Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
> The substitution of the brushes cable of the power tool should be accomplished by
an authorized and qualified technical service.Brushes out of specification can
cause damages to the motor of the power tool.
> If the power cord is damaged, the power cord shall be replaced by manufacturer,
re-service or qualified person to avoid the risk of electrical shock.
05
SAFETY WARNINGS WHICH ARE COMMON FOR POLISHING OPERATION
> This power tool is intended to function as a polisher. Read all safety warnings,
instructions,illustrations and specifications provided with this power tool. Failure to
follow all instructions listed below may result in electric shock, fire and/or serious injury.
> Operations such as grinding, sanding, wire brushing or the cutting-off are not
recommended to be performed with this power tool. Operations for which the power
tool was not designed may create a hazard and cause personal injury.
> Do not use accessories which are not specifically designed and recommended by
the tool manufacturer. Just because the accessory can be attached to your power
tool, it does not assure safe operation.
> The rated speed of the accessory must be at least equal to the maximum speed
marked on the power tool. Accessories running faster than their rated speed can
fly apart.
> The outside diameter and the thickness of your accessory must be within the
capacity rating of your power tool. Incorrectly sized accessories cannot be
adequately guarded or controlled.
> Threaded mounting of accessories must match the grinder spindle thread. for
accessories mounted by flanges. the arbour hole of the accessory must fit the
locating diameter of the flange. Accessories that do not match the mounting
hardware of the power tool will run out of balance, vibrate excessively and may
cause loss of control.
> Do not use a damaged accessory. Before each use inspect the accessory such as
abrasive wheels for chips and cracks, backing pads for cracks, tear or excess wear,
wire brushes for loose or cracked wires. If the power tool or accessory is dropped,
inspect for damage or install an undamaged accessory. After inspecting and
POWER TOOL-SPECIFIC SAFETY WARNINGS