USING
Starting Operation
Inserting the Battery
Use only original XTLINE lithium ion batteries with the voltage listed on the nameplate of
your power tool. Using other batteries can lead to injuries and pose a fire hazard.
Set the rotational direction switch 7 to the centre position in order to avoid unintentional
starting. Insert the charged battery 5 into the corresponding place of the machine.
Reversing the Rotational Direction
The rotational direction switch 7 is used to reverse the rotational direction of the machine.
However, this is not possible with the On/Off switch 8 actuated.
Right Rotation: For drilling and driving in screws, push the
Gear Selection, Mechanical
Actuate the gear selector 4 only when the machine is at a standstill. Two speed ranges can be preselected with
the gear selector 4.
Low speed range; for screw driving or working with large drilling diameter.
High speed range; for working with small drilling diameter.
If the gear selector 4 cannot be fully engaged, lightly rotate the drive spindle with the drill bit by twisting
the drill chuck.
Switching On and Off
To start the machine, press the On/Off switch 8 and keep it pressed.
The light 6 is lit when the On/Off switch 8 is slightly or completely pressed in and permits to light the work area when
the lighting conditions are bad.
To switch off the machine, release the On/Off switch 8