MAINTENANCE
WARNING. Always ensure that the tool is switched off and the plug is removed from the power
point before making any adjustments or maintenance procedures.
Keep the tools air vents unclogged and clean at all times.
1.
Regularly check to see if any dust or foreign matter has entered the grills near the motor and
around the trigger switch. Use a soft brush to remove any accumulated dust. Wear safety glasses to
protect your eyes whilst cleaning.
2.
Re-lubricate all moving parts at regular intervals.
3.
If the body of the sander needs cleaning, wipe it with a soft damp cloth. A mild detergent
can be used but nothing like alcohol, petrol or other cleaning agent.Never use caustic agents to
clean plastic parts.
CAUTION!Water must never come into sparking seen through the ventilation slots. When the
carbon brushes have worn down to approximately 4-5mm, they will require replacing.
Caution! Make sure that the sander is isolated from the mains power supply before fitting
accessories, maintenance and adjustment if in doubt consult a qualified electrician.
Place the sander on a workbench and using a screwdriver remove the carbon brush housing cover
(see 1 of Fig.10).
Remove the carbon brush from the brush housing and replace it with a new one. Slide the new
carbon brush (see 1of Fig.11) into the brush housing. Repeat this procedure for the other carbon
brush. Then replace the carbon brush housing cover.
Note: carbon brushes must be replaced in contact with the sander.
4.
During use, the carbon brushes will wear down and will be indicated by a possible loss of
power and excessive
