19
To lubricate your treadmill belt:
1.
Ensure that your machine is off, and unplugged to minimize risk of injury.
2. Reach between the belt and the top of the treadmill base to verify that lubrication is present.
3. While kneeling beside your treadmill deck, use one hand to hold the treadmill belt up and
away from the treadmill base just enough so you can use your other hand to reach the
lubrication underneath.
4. Starting about 1 foot from the motor cover, begin applying ½ of your lubricant bottle in a
long “S” pattern about 4-6” from one edge.
5. Repeat steps 3 and 4 on the opposite side using the remaining ½ of the lubricant bottle.
6. Plug the treadmill power cord back in, and turn the power switch back on.
7. Walk on the belt at a moderate speed for 5 minutes to evenly distribute the lubricant along
the treadmill belt and deck.
8. Your treadmill belt is now lubricated. Normal use can resume.
Note: If your console display is showing a “LUBE” message, perform the following procedure to
reset the display:
1. In standby mode, hold the PROGRAM key for 3 seconds to reset the message.
To clean your treadmill belt:
1.
Ensure that your machine is off, and that the power cord is unplugged to minimize risk of
injury.
2. Grab one edge of the treadmill belt, and lift slightly to expose the area between the top of
the treadmill base and the running belt.
3. Do a visual check for any dirt or debris accumulation.
4. Should dirt and debris be present, slide a towel or cleaning cloth between the treadmill belt
and top of the treadmill base until you can grasp one end on each side. (The cleaning cloth
should be longer than the running belt is wide to achieve this.)
5. Using both hands, drag the cleaning cloth up and down the length of the treadmill base 1-2
times.
6. For excessive dirt accumulation, rotate the belt halfway, and repeat step 5. Continue until
your cleaning cloth is no longer picking up any dirt.
7. Remove cleaning cloth from treadmill before plugging back in.
