Customer Service 1-888-707-1880
Dyaco Canada Inc. 2019
Email: [email protected]
19
TREADBELT TRACKING ADJUSTMENT:
The performance of your treadmill is dependent on the frame running on a reasonably level
surface. If the frame is not level, the front and back roller cannot run parallel, and constant
belt adjustment may be necessary.
The treadmill is designed to keep the treadbelt reasonably centered while in use. It is normal
for some belts to drift near one side while the belt is running with no one on it. After a few
minutes of use, the treadbelt should have a tendency to center itself. If, during use, the belt
continues to move toward one side, adjustments are necessary.
TO SET TREADBELT TRACKING:
A 6 mm Allen wrench is provided to adjust the rear roller. Make tracking adjustments from the
left side only. Set the belt speed at
approximately 2 to 3 mph. Be aware that
a small adjustment can make a dramatic
difference which may not be apparent
right away. If the belt is too close to the
left side, then turn the bolt only a 1/4 turn
to the right (clockwise) and wait a few
minutes for the belt to adjust itself.
Continue to make 1/4 turns until the belt
stabilizes in the center of the running
deck.
If the belt is too close to the right side, turn the bolt counter-clockwise. The belt may require
periodic tracking adjustment depending on use and walking/ running characteristics. Some
users may affect tracking differently. Expect to make adjustments as required to center the
treadbelt. Adjustments will become less of a maintenance concern as the belt is used. Proper
belt tracking is an owner responsibility common with all treadmills
ATTENTION: DAMAGE TO THE RUNNING BELT RESULTING FROM IMPROPER
TRACKING / TENSION ADJUSTMENTS IS NOT COVERED UNDER THE WARRANTY.
