11
4
#115
. M5 × 15mm
Phillips Head Screw
(14 pcs)
#119
. 3.5 × 12mm
Sheet Metal Screw
(8 pcs)
#122
. M6 × 10mm
Phillips Head Screw
(4 pcs)
Plastic Covers
Hardware Step 4
Note:
Use the Phillips Head Screw Driver (
157
) to tighten the hardware in this step.
1.
Install the two Wheel Covers (
79
-Left &
80
-Right) with four Phillips
Head Screws (
115
).
2.
Install the Center Cover (
85
) with four Phillips Head Screw (
115
).
You need to raise the incline to install the Center Cover.
3.
Install the Swing Arm End Cap Covers (
81
&
82
-Left,
83
&
84
-Right)
with the eight Sheet Metal Screws (
119
).
4.
Install the two ‘Z’ shaped metal brackets (
24
) as shown with four
Phillips Head Screws (
122
). The Z Brackets should be installed so
the tab with the tapped hole is pointing toward the rear.
5.
Install the Rear Incline Cover (
87
) with two Phillips Head Screws
(
115
). Install the Rear Stabilizer Cover (
88
) with four Phillips Head
Screws (
115
).
Summary of Contents for FS5.8e
Page 1: ......
Page 8: ...8 1Rear Rail Console Mast Console ...
Page 26: ...26 EXPLODED VIEW DIAGRAM ...