Customer Service 1-888-707-1880
27
Dyaco Canada Inc. 2021
Email: [email protected]
TROUBLESHOOTING
ERROR MESSAGES
E0:
Safety switch is open. The safety switch has malfunctioned or is intermittent.
E2:
Treadmill is overloaded, and the protection device of the controller is activated. Check if the tread
belt has shifted and movement is obstructed. Check if lubrication is sufficient, the friction is high. The
bearings in the belt rollers could be worn.
E4:
Abnormal voltage between motor terminals. Motor cable is not properly connected.
E5:
Communication between console and controller is disconnected. Check if console and drive board are
connected properly with connecting cable is free from damage.
E6:
Controller is defective. Controller component malfunction.
Er:
Incline malfunction. Check if incline cables connected properly. Check if incline mechanism is stuck or
defective. Perform calibration procedure.
Engineering Mode
1.
In Idle mode pull off the safety key; the display shows E0.
2.
Pressing and hold PROGRAM key and replace the safety key, the unit enters engineering mode.
3.
Press the Clear/Set key to change the set value and use SPEED and INCLINE UP/DOWN keys to make
selection.
i.
At first is Metric/English selection for km/h or mph readings. Press Clear/Set after setting
ii.
Then it follows with “0” and “1” being displayed. “0” is to switch off the audible beep sound; “1”
is to switch it on. Press Clear/Set after setting.
iii.
The wheel size is set at 60. Press Clear/Set after setting.
iv.
Minimum speed is set at
5
for speed
0.5
. Press Clear/Set after setting.
v.
Maximum speed is set at
120
for speed
12
. Press Clear/Set after setting.
vi.
Incline level is set at 10 for level 10 or 12 for level 12. Press Clear/Set after setting.
4.
Press the START key to enter automatic calibration.
5.
The console returns to idle mode when calibration is completed.
