■
Operation for Guard Unit related function
If Guard Unit is installed in the system, you can contact it by the operation as below.
1.
When standby, press anywhere on the screen,
then press icon(or press INTERCOM
Button in standby), to activate the INTERCOM
FUNCTION MENU as shown on the at right.
2.
Press CALL GUART UNIT
item, a message
will be sent to Guard Unit, after the screen
displays
CALL MESSAGE SEND OUT...,
you can turn off and wait Guard Unit to call
back. When receiving the call from Guard Unit, the Monitor will rings in a different
tune from other calls, and the screen may be in shut-off state (which depends on the
system configuration).
3. Press DIRECT DIAL GUARD UNIT item, it will directly dial to the Guard Unit,
then the screen will displays DIALING GUARD UNIT... PLEASE WAIT. If Guard
Unit answers the call, you can talk with the guard person. However, If the system is
busy, you have to try again later.
■
Operation for Intercom
1. Intercom among Monitors can be started
by direct dialing the target room code.
2.
When standby, press anywhere on the
screen, then press icon(or press
INTERCOM Button in standby), to activate
the INTERCOM FUNCTION MENU. Then
press the INTERCOM CALL
item, you will
see a keypad on screen as right.
3.
To call the room in the same building with you, just left the Building code to be
“000”, and directly input the Room code and then press [#] to dial; to call Monitor in
other buildings, you should input Building code after the Room code, then press [#]
to dial. During input state, press [*] to backspace and re-input number.
4.
Note: Intercom will be available only when the system is free. Intercom function is
prior to monitor function, but calling function is always the first.
- 5-
