3
*
The instructions of button:
Button
Descriptions
Reset
-Press Reset button,it will reset GSM kits
Signal Quality
-Press Signal Quality button,it will show the signal strength
Recover
-Press Recover button,it will recover the password defaults
Test
-Press Test button,it will call the monitor 00
*
NOTE:
Signal strength show:After press Signal Quality key, 4 LEDs off for a second,
then the GSM kits will use 4 LEDs to display signal strength(no signal: 4 LEDs
off; bad signal: only the LED of Power on; weak signal:only the LED of Power
& Network on; good signal: the LED of Power & Network & Status on; strong
signal:4 LEDs on)for a second, and 4 LEDs off again for a second later, it will
back to the start state.
2.
Mounting
Din rail
Step1: Mount the din rail to the
wall with screws ;
Step2: Pull down the mounting
buckle,then hang the unit on
din rail.
Din rail
Mounting Buckle
Antenna
NOTE:A magnet installed on the antenna base, fixed on the
wall directly adsorbed iron (iron Fortunately, pre-installed on
the wall) place. In addition, the antenna should be installed
in the open place, there should be no obstructions around.
