XTC X Series Assembly Manual Download Page 2

Page: 2 / 2

With a helper, place

Upright

between the

Triangle Plate

, attach with 5” Bolts. Finger tighten

hardware.

STEP 6.

Repeat Step 5 for the opposite side.

STEP 7.

With a helper, place the

Crossbeam 2

at your desired height and use 4.5” Bolts to join the three

parts. Finger tighten hardware.

STEP 8.

Line the

Multi-Grip Chin-up

to the left-most hole on 3” face of the

Crossbeam 2

installed in Step

7. Use 3.5” Bolt and connect components, finger tighten hardware. Then swing

Multi-Grip Chin-

until horizontal and align with right second last hole from the right, use 3.5” Bolt and

connect components, finger tighten hardware. Using 3.5” Bolt place through the center hole of
the

Multi-Grip Chin-up,

finger tighten hardware.

STEP 9.

Fasten all hardware completely.

STEP 10.

Using a Rubber Mallet install

2x3” Plastic

into the

Lateral Base Tubes

Summary of Contents for X Series

Page 1: ...Socket 1 15 16 Wrench or 24mm Wrench 1 Rubber Mallet 1 Ladder or step stool INSTRUCTIONS STEP 1 Place Lateral Base in position where you wish to assemble rack with the 3 face down 43 apart and parall...

Page 2: ...up to the left most hole on 3 face of the Crossbeam 2 installed in Step 7 Use 3 5 Bolt and connect components finger tighten hardware Then swing Multi Grip Chin up until horizontal and align with rig...