The PCS-S2-
KBUS attaches to the OEM winch cable for power. The cables are cable tied on the driver’s side
under the dash. Remove the cables and Tape covering the cable connectors. Two pieces of Heat Shrink are
provided to help protect the factory Cable. Slide the Red Shrink over the Factory Red Cable and Heat using a
Heat Gun. Do the same for the Black Cable.
Attach the Red Cable to the right-hand post with the Red Wire, attach the Black cable to the Left-hand Post.
Attach any fused accessory power to the Orange wire and the accessory ground wire to the Black left post.
There is an extra post that can be jumped to the positive or negative post for extra hookups.
At the Battery Box find the Winch cable taped to the back of the box , remove the tape and attach the winch
cables to the battery per the manufacturers winch Hook-up Instructions.
If a winch has been installed, use the
provided jumper wire to go from the winch
relay ground to the Busbar Ground. Attach
the red wire with the fuse holder to the
positive post on the winch relay.
Only attach accessories that have their own fuse to the Systems output post, Orange Wire Post.
For more details on installation go to www.xtcinstall.com
We can also be reached by email at
XTC Power Products
A Division of XTC Motorsports LLC
925 N McQueen RD. #101
Gilbert AZ 85233
480-558-8588
www.xtcpowerproducts.com
*Disclaimer: This kit is intended for off road use only and XTC Motorsports claims no responsibility for it use. It is up to the purchaser to make sure
it complies with all Federal, State and Local laws.
R1
Copyright © 2020 XTC MOTORSPORTS LLC, all rights reserved.
