XTA DP224, Operator'S Manual

Page: 55 / 59

DP226 Operators Manual Page 55
How Do I Configure The Interface?
The GPI Interface sub-menu is at the end of the menu list accessed by pressing
‘MENU’ and scrolling using the ‘NEXT’ key, until the screen shows...
<- Main Menu. . . . . . .
Remote GPI Sub-Menu
Pressing ‘ENTER’ will access the interface sub-menu which is configured as a ‘wizard’,
leading the user through the required parameters.
Pressing ‘ENTER’ will display
Remote GPI Menu
Interface Setup
There are only currently two parameters to configure for correct operation. These
are outlined below.
Firstly, choose the format (operation mode) of the interface, or disable it by setting
this parameter to the ‘OFF’ position. Use the ‘BACK’ and ‘NEXT’ keys to choose
from ‘COMPLEX’, ‘SIMPLE’ or ‘OFF’. The use of the formats is explained in
following sections. ‘COMPLEX’ allows recall of up to the first 31 memories; ‘SIMPLE’
allows the first 7 to be accessed. Press ‘ENTER’ when ready.
<- Interface Setup ->
GPI Format: COMPLEX
Next, choose whether the recall will operate on input memories, output (crossover)
memories, or both. Choosing ‘Both’ means that corresponding input equalisation and
output crossover settings will be recalled simultaneously. Assure that the correct
input and output settings are in corresponding memory numbers (input memory 01
with crossover 01 etc.) to avoid accidental recalling of incorrect configurations!
<- Interface Setup ->
Memories: Outputs
Finally, after pressing ‘ENTER’ to accept these new settings, a final warning message
is displayed. Press ‘ENTER’ again to confirm the changes, or press ‘QUIT’ to cancel
all changes and revert to the default screen.