Page
5
of
12
XStatic Pro Lighting Tornado LED Fog Machine Manual
Operation:
Plug the Tornado LED Fog Machine to 120V AC. The device need few
minutes for preheating. It will display
UP
when heating, and tank LED glow
red
at that time. When it has reached the operational temperature and
ready to fog, it will display
READY
and tank led glow
blue
at this time
Note: When there is no fog fluid in tank, the display board will flashing and
show
no oil
and at the same time the tank LED (Red+Blue) is flashing. At
that point all other controllers are unavailable, except the manual button.
Please add the liquid then press manual button until the fog juice is
detected, the display board will show
"READY"
again after that action.
Fog Juice Level Sensor:
The Xstatic Tornado Fog machine features a fog juice level sensor. When
the fog juice level is low, a LED below the reservoir will flash. When the fog
juice level reaches a critical level, a sensor inside the reservoir will
automatically shut off the pump. This is designed to protect the pump. The
unit has a heating element that has been specially designed to prevent
excessive particle build up that can cause premature failure.
Caution:
Before removing or replacing the timer control unit or adding fog juice,
always disconnect the power supply.
Be sure to maintain an adequate supply of ProX Brand Fog Juice in the fluid
reservoir. Running the fog machine dry will cause pump failure and or
clogging. This is the largest cause of failure in fog and haze machines. ProX
Fog Juice is required to maintain your warranty
.
Available Fog Juice to purchase from your ProX Dealers:
FJ-1H
: 1 GALLON HIGH DENSITIY PLAIN (UNSCENTED)
FJ-1P
: 1 GALLON PLAIN (UNSCENTED)
SCENTED JUICE:
Tropical Fruit, Strawberry, Vanilla, Fruit Punch and more…
