Xsarius i-GO HD1, Manual

Page: 60 / 64

MADE TO ENJOY
© Copyright 2011 - Xsarius
60 61
English
Problem Possiblecause Solution
LED on front panel does
not light AC Power cord
disconnected Connect power cord properly into
the power socket
No picture or sound Wrong connection of the Video/audio
output to TV input terminal
Wrong connection of antenna cable
No signal or weak signal
Wrong setting of channels Information
in MENU screen
Connect two terminals correctly
With SCART, RCA or RF cable
Connect the antenna cable correctly
Type the setting value correctly
Check the cable connections
and Satellite-Dish alignment
Type the setting value correctly
Black-and-white screen
or V-Hold Your TV mode is different from
broadcasting mode Use TV of same mode
Use the NTSC/PAL converter
Connection to the receiver and TV
The remote control is
not working Battery exhausted Change the batteries
Fluorescent light interfering with the
remote control Switch off the light
Remote control is incorrectly aimed Aim the remote control at the
receiver
Distorted menu screen Too high brightness and contrast level
of TV set Adjust brightness and contrast to
low level
Not working Process down Switch off the receiver, remove the
power cord. After a short moment
re-insert the power cord and switch
on again.
8 Trouble shooting