8
UM Termometri serie 7Vio ENG rev.0 14.04.2021
•
LED
All instruments are equipped with a two-color LED (red and green) that provide the user with important
information about the system status:
Function
LED
Description
Power on
GREEN
Fixed on
Power off
RED
Fixed on
Instrument in Standby
GREEN
Flashing every 20 s
Stable Measurement
GREEN
Flashing every 3 s
Error during measurement
RED
Flashing every 3 s
Confirmation of one selection
GREEN
On for 1 s
Setup
•
Supplied components
The instrument is always supplied inside the specific carrying case; the version without sensor is
always supplied with:
instrument with batteries, screwdriver, user manual.
There are versions with sensor already included. Contact your local distributor to be updated on the correct
composition of the sales kit.
•
Start-up
•
The device leaves the factory ready to be used by end-user.
•
Batteries are included.
•
Switching On/Off
Turn on the system by pressing the button
. The display initially activates all segments and then
appears:
•
model and firmware of the instrument;
•
settings related to the most important parameters;
•
the instrument switches on temperature measuring mode;
•
to switch off the instrument, press the key
in measure mode.
•
Batteries replacement
The instrument works with 3 AA 1.5V batteries.
To proceed with the replacement:
1.
Turn off the instrument;
2.
turn the instrument downwards, with the part of the connectors resting on a support plane, so that
the battery-stop cap faces up, towards the user;
3.
holding down the battery stopper with two fingers, with the screwdriver provided, completely unscrew
the screw close to the battery symbol;
4.
Remove the battery stopper cap with the help of the lanyard;
5.
Remove the 3 exhausted batteries and insert the new ones. Pay attention to the correct polarity. Follow
the diagram above the battery symbol in the rear compartment of the instrument;
6.
Reinsert the battery stopper cap; always hold it with two fingers, insert the screw and tighten.
