7
DECORATING THE BODY
The micro truck body was hand-painted with premium-quality, high-gloss paint and several stickers were applied to the body.
If you want to use the included rear wing, you must trim it fi rst. To install the wing on the M18MT Monster Truck make two holes in the rear of the body as indicated. Attach the
rear wing to the body using the included screws and plastic nuts. To install the wing on the M18T Truck use double-sided tape.
Extra decals are provided to decorate and personalize your micro truck body.
Use the tip of a hobby knife to lift the corner of a decal, then remove it from the backing sheet.
Position the decal over the desired location on the body, and press it onto the body. Pull tight on the decal if required, and use your fi ngers to smooth out any air bubbles.
Decals for M18T
Decals for M18MT
FILLING AND INSTALLING THE SHOCK ABSORBERS
Remove each shock absorber, fi ll each shock absorber with the supplied shock oil, and re-install on the micro truck.
REMOVING THE SHOCKS
FILLING THE SHOCKS
INSTALLING THE SHOCKS
Thread the shock cap onto the shock body.
Excess oil should spill out.
Fill until shock oil nearly overfl ows
Gently move the piston up and
down to get rid of air bubbles
Pull down
the piston
OIL
TEAMXRAY
Remove clips
Remove shock collar and
spring from each shock (front
and rear)
Remove all shocks
(front and rear)
Unthread the shock cap from
the shock body and remove
the shock membrane.
Pull down
the piston
Insert clips according
to track conditions
INITIAL POSITIONS
RE-INSTALL ALL SHOCKS
(front and rear)
Double side tape
Wing
Body
Note how the shocks are attached
(especially on M18MT Monster Truck).
Summary of Contents for m18mt
Page 1: ... ...
