background image

1

 | 

XPRESSFILL Systems LLC

 

XPRESSFILL Systems LLC

 | 

1

Set Up Your Filler

1. 

Unpack the fi ller from the box.  Place is on a 

fl at surface where you plan to bottle.

Tip:  To get familiar with your fi ller, you may 

want to initially test it with water.

2.  

Connect the quick connect plug into the 

machine.  Make sure the inline strainer is 
mounted in the correct direction (an arrow on 
the side shows the fl

  en place the 

other end of the Transfer Kit in your product.

Note:  Your product needs to be placed below

3.  

Plug the fi ller into a wall outlet.  Turn on 

  e Digital Timer shows 

time in seconds. 

4.  

To change the fi ll time on your XF460, 

simply follow these steps:

Each digit can be changed with the 

a. 

numbered push button below the display.  
Once you dial in your desired time, press 
the RST button to save the changes

Refer to your fl ow calibration sheet to 

b. 

get an idea where to start with the time 
setting for your volume of product.

5.  

 Place your bottles under each of the four 

spouts.  Push the start button or hold the 

manual button to allow the pump to prime
until you notice a consistent flow. 

Note:  To make sure there is no air in the fl ow 
path, turn the inline strainer upside down
while the pump is priming.  This ensures that
the air bubbles in the strainer housing mostly 
dissolves, although a little air bubble in the 

strainer is normal.

6.  

Empty the bottles and place them back 

under the spouts, then press the start button.  

  e digital timer will count down the fi ll time.  

During the fi rst cycle, be ready to hit the stop 
button in case you set the time too long.  You 
then can refi ne your level by changing the time.

Summary of Contents for XF460










Reviews: