EX9 Wireless Radio Keypad User Manual v1.3
8
8) TOTAL RESET
Total reset of EX9-43B
MOTE: IN CASE OF TOTAL RESET ALL THE USERS ARE DELETED, THE MASTER CODE AND
ALL THE SETTINGS ARE RETURN FACTORY DEFAULT.
Total Reset of RX2
1. Cut the power supply of the receiver’s card
2. Keep pressed the tact switch button and supply power again to the receiver: led 1 turns on after
approximately 5 seconds.
3. Release the button of the receiver
4. Wait for the blinking (2 or 3) of LED1. All codes are cancelled once turned off.
9) OPERATING THE WIRELESS KEYPAD
To operate your wireless keypad, type the
Code
then
A
then the
Number of the transmission
channel
.
Example: If your code is 1234, to activate the relay press:
1234 +
A
(Long beep)
+
1
(
short beep and green led blinks for transmission time)
10 ) EXAMPLES
Task:
Assign User with Code: 1234, to activate relay 2. The Relay 2 has to stay open as long as the
radio signal persists, assuming that the Master Code is 5555.
1. Enter the Master Code 5555 and press B, Press 0, press 01, press 1234, press A, press B
2. Take the Radio receiver. OPEN the Jumper B (immediate mode). Press the Tact Switch Button
twice and LED1 and LED3 will be on. On the Keypad pres
1234+A+1
and LED3 (green) on the
radio Receiver will blink 3 times indicating that the Code is memorized.
Try the Code, press
1234 + A + 1
and
relay 2
will go ON.
Keep reset key pressed
DO NOT release the key
Beep
emitted by the keypad
DO NOT release the key
DO NOT release the key
The keypad continuously
Beeps
Two Beeps
emitted by the keypad
Three Beeps
emitted by the keypad
Release the key
