ENROLLING FINGERPRINTS FROM DESKTOP READER
8.13
8.9
8.11
8.10
8.12
8.7
Plug
the
Swipe
Desktop Reader
in the PC. If the device is not installed automatically
us
e
the drivers located on the CD provided with
the Biometric reader. It is installed in the same way as a USB Device. When the desktop reader has been installed it will
automatically appear in the Software
. (8.13)
1. Open the Users Window and create a new user.
Click on “New User”, put a name and ID(card number). (8.7)
2. Go to the “Biometric” Tab
3. Select the USB Swipe desktop Reader (with left click).(8.8)
4. Right click on the fingertip and select enroll. (8.9)
5. In the next 25 sec. swipe the finger on the selected reader min. 5 times and the finger tip will turn red. (8.10)
In these 25 sec. the reader will continuously blink in orange.
6. Repeat point 4&5 for each finger that should be enrolled.
7. Click on “Save New” and the fingerprint will be sent automatically to all Biometric Readers where that user has access, i.e. to
all the readers according to the Access Level assign to that user.
Example:
If the user has “Unlimited” Access level then the fingerprints will be sent to all readers, if the user has Access level only for
Reader1 and Reader 3 then the fingerprints will be sent only to those two readers.
Note:
To check if all the fingerprints are sent to the reader, right click on the reader and select “Memory Status”. (8.11)
In the event window a line will appear indicating the number of fingerprints stored in the reader. (8.12)
Note:
If more fingerprints are added for one user, all fingerprints will send the same Wiegand Code to the controller, the one written
in the field User ID(card Number).).
x 5
10
