https://www.XPOtool.com
Item 63319
Page 6
The Tool Experts
05 2022-1
6.
Re-place the locking screw
(3)
of the feed roll.
7.
Re-place the pressure control lever
(2)
to its initial position and re-adjust the pressure regula-
tor
(1).
Inserting the wire spool
This welding machine is only suitable for 10
cm diameter wire spools. Insert the wire spool as follows:
1.
Open the welding machine cover, remove the locking screw
(1)
and the spacer from the wire
spool.
2.
Slide a 10
cm diameter wire spool onto the wire shaft and re-place the spacer and locking screw.
Threading welding wire through drive motor up to welding gun
Note!
This welding machine can only use self-shielding filler wire sized 0.8 or 1.0
mm.
Install the welding wire as follows:
1.
Switch off the power switch and disconnect the welding machine from the power supply.
2.
Remove the contact tip and nozzle from the end of the welding gun.
3.
Make sure that the feed roll is installed in a position appropriate for the size of the wire used.
4.
Unlock the pressure regulator
(1)
and lift the pressure control lever
(2).
Make sure that the feed
roll is suitable for the size of the welding wire used (see previous section). The feed roll is pre-
installed for 1.0
mm wire.
5.
Carefully remove the welding wire from the wire spool.
Note!
Do not let go the wire, otherwise the entire spool could unwind itself.
6.
Cut off the small piece of the bent segment of the front end of the welding wire and align the
welding wire for about 8
cm (3.0″).
7.
Thread the welding wire into the wire feed
(4)
via the wire drive roll up to the wire feed of the
welding gun.
8.
Re-place the pressure control lever
(2)
to its initial position and re-adjust the pressure regula-
tor
(1).