https://www.XPOtool.com
Item 63316
Page 4
The Tool Experts
05 2022-1
•
The welding machine can only be used for welding. Any improper use (e.g., defrosting pipes,
recharging batteries, or heating) is strictly forbidden.
•
Do not touch hot workpieces with bare hands; otherwise, you will be severely burnt.
•
During permanent use of the welding machine, cooling is necessary.
•
Magnetic fields impair pacemakers.
•
Persons equipped with pacemakers should leave the immediate welding zone before having
consulted a doctor.
•
Moving parts can provoke injuries.
•
Therefore, keep hands, hair, and tools aways from moving parts such as the fan to avoid injuries
or damages to the machine.
•
All doors, panels, covers, and other protective devices must be closed during operation.
Working environment
•
Welding should be performed within a dry environment.
•
The temperature within the working zone should be comprised between -10
℃
and 40
℃
.
•
Avoid welding outdoors, unless you be protected from sunlight and rain. Always keep the ma-
chine dry and do not place it to a wet ground or in a puddle.
•
Avoid welding in dusty areas or in areas with presence of corrosive chemical gases.
•
Gas-shielded welding should be performed in a zone without a lot of draught.
Ventilation
During welding, there is presence of a heavy current; therefore, the natural draught cannot provide
sufficient cooling. Ensure good ventilation via the ventilation slots of the machine. The minimum distance
between the machine and all other objects within or near the working zone should be 30
cm. Good
ventilation is vital for the normal performance and service life of the machine.
Welding
This welding machine is equipped with an overcurrent protection, overvoltage protection, and overheat-
ing protection. If the input voltage or output current is too high or the inner temperature of the machine
gets too hot, the machine switches itself off automatically. When used too much (e.g., use with too high
a tension), the machine might be damaged; take account of it.
Welding is forbidden with the machine being overcharged. Bear in mind to always respect the maximum
load current (see corresponding duty cycle). Make sure that the welding current does not exceed the
maximum load current. If the machine is overcharged, its service life can be reduced or it might even be
damaged.
Overvoltage is forbidden. The tension range for the power supply of the machine is given in the “Welding
parameters” chart (see below). The machine is equipped with an automatic tension compensation that
keeps the tension range within the rated range. Should the input tension exceed the given value, the
components of the machines might be damaged.