XPOtool 62971 Operation Manual Download Page 3

 

https://www.XPOtool.com 

 

Item 62971, 62972

 

Page 3 

 

The Tool Experts

 

 

  

 

01 2022

-1

 

 

Introduction

 

 

Thank you for purchasing this quality product.

 To minimise the risk of injury we urge that our clients 

take some basic safety precautions when using this device. Please read the operation instruc-
tions carefully and make sure you have understood its content.

 

Keep these operation instructions safe.

 

 
 

Safety instructions

 

 

Caution!

 

When  using  the  appliance,  some  safety  precautions  must  be  observed  to  avoid  injury  and  damage. 
Read the operating instructions and the safety instructions completely and carefully. Keep these instruc-
tions in a place where you can access them at any time. If you pass the appliance on to someone else, 
pass on these operating instructions and the safety regulations as well. We accept no liability for damage 
or accidents caused by failure to follow these instructions and the safety instructions.

 

 

 

The series battery chargers are designed for charging lead-acid batteries, gel batteries and 
AGM  batteries.  They  cannot  be  used  as  a  DC  power  source  or  for  any  other  purpose  to 
prevent accidents such as fire and electric shock.

 

 

The  charger  is  only  designed  for  a  suitable  power  outlet.  If  the  power  cable  needs  to  be 
extended, ensure that the extension cable is of sufficient size to supply power over the re-
quired distance.

 

 

If the charger is interrupted while charging or other damage is caused by exposure to a violent 
impact, discontinue use immediately.

 

 

The charger must not be disassembled. If repairs are necessary, they must be carried out by 
a qualified electrician. Improper reassembly may result in a fire hazard and/or electric shock.

 

 

Disconnect the charger from all connected batteries and from the mains before cleaning the 
housing.

 

 

Disconnect the charger from the mains after charging is complete. Then remove the battery 
connector.

 

 

Warning! 

Explosive gases are produced during charging; therefore, avoid sparks and naked 

flames or smoking in the vicinity of the unit.

 

 

Only charge the battery in ventilated rooms. It is strictly forbidden to use the unit in a vehicle 
or under the closed bonnet.

 

 

The battery charger cannot be used for non-rechargeable batteries.

 

 

If the mains cable is damaged, it must be replaced by a qualified electrician to avoid a hazard.

 

 

The battery terminal that is not connected to the vehicle must be connected first. The other 
connection must be made on the vehicle, at a sufficient distance from the battery and the fuel 
line. The battery charger must then be connected to the power supply.

 

 

This appliance is not intended for use by persons (including children) with reduced physical, 
sensory, or mental capabilities, or lack of experience and knowledge, unless they have been 
given supervision or instruction concerning use of the appliance by a person responsible for 
their safety. Children should be supervised to ensure that they do not play with the appliance.

 

 

Batteries  store  a  large  amount  of  energy.  Be  sure  to  avoid  short-circuiting  the  battery  or 
charger terminals, otherwise the energy stored in the battery will be released immediately. 
This may result in fire or injury.

 

 

Do not allow children to play with the appliance.

 

 

Cleaning and user maintenance must not be carried out by children without supervision.

 

 

 

Summary of Contents for 62971









Reviews: