https://www.XPOtool.com
Item 62834
Page 11
The Tool Experts
01 2022
-1
Adjusting the groove depth
1.
Loosen the locking screw
(18).
2.
Set the depth stop to the desired depth. To do this, adjust the protective cover
(5).
3.
Fasten the protective cover
(5)
again with the locking screw
(18).
Dust extraction
•
The device generates a large amount of dust during operation. You should therefore wear a
dust mask and always connect an extraction system or an industrial vacuum cleaner.
•
If the extraction system malfunctions, stop operation and remedy the malfunction.
Connecting the dust extraction system
•
Unscrew the dust exhaust connection cap
(10).
Introduce the hose of the industrial vacuum
cleaner through the cap and screw it tight.
•
If the hose of your vacuum cleaner has the wrong diameter for a direct connection, you can
insert the adaptor
(11)
in between.
•
Always connect an extraction system or an industrial vacuum cleaner to prevent damage to the
engine.
Operation
Caution!
Risk of injuries!
•
Always pull the power plug before maintaining or adjusting the device.
•
Only use cutting wheels and accessories recommended by the manufacturer. Using other ac-
cessories might be dangerous.
•
Only use cutting tools that have information on the manufacturer, the type of binding, the di-
mensions, and the permissible rotation speed.
•
Only use cutting wheels with a speed printed on them that is at least as high as that specified
on the nameplate of the device.
•
Do not use broken, cracked or otherwise damaged cutting wheels.
•
Never operate the device without protective equipment.
•
Support panels or large workpieces to reduce the risk of kickback from a jammed cutting wheel.
Large workpieces might bend under their own weight. The workpiece must be supported on
both sides of the wheel, not only near the cutting wheel, but also on the edge.
Keep your hands away from the cutting wheel when using the machine. Risk of in-
jury.
Switch off the device and pull out the power plug. Let the device cool down.
Switching on/off
Make sure that the supply voltage corresponds to the one specified on the nameplate.
Connect the device to the power supply.
1.
To start the device, push the switch lock
(3)
forwards. Then press the on/off switch
(2).
2.
To switch off, release the on/off switch. The device turns off.
After switching on the device, wait for the device to reach its maximum speed. Only then do you start
work.
