https://www.XPOtool.com
Item 61909
Page 6
The Tool Experts
05 2022-1
7. Position the jaw frame on the main stand base and tighten it
with the supplied 12
mm cheese head screws and nuts. You can
now use the device.
General information
•
This tyre changer is suitable for all wheel sizes between 101.6
mm (4″) and 434
mm (17″). The
tyre is held in place by two adjustable jaw clamps with holes and an adjustable slide jaw clamp.
Two centre posts (four shaft sizes) are provided either for the centre of the bearing or for the
centre of the hub.
•
When servicing bearing-centred wheels, use a centre shaft corresponding to the bearing size
of the wheel (12.7
mm [½″], 15.9
mm [⅝″] or 19
mm [¾″]). Once the wheel is in place, insert the
appropriate post into the wheel bearing.
•
Maintenance of hub-centred wheels uses a large diameter post. Insert the post directly into the
middle of the arms as soon as the wheel is in place.
Operation instructions
Slide clamps are positioned to the correct wheel size as indi-
cated by numeric markings on each arm. The pins are inserted
on the outside of the terminals. Press the two clamps against
the pins.
