https://www.XPOtool.com
Item 61856
Page 6
The Tool Experts
05 2022-1
Bending springs
1.
Remove the mounting plate for dies
(4)
by removing the two hexagon screws. Loosen the
stop
(2).
2.
Pull the bending block unit
(16, 17, 22–24)
all the way back. Remove the front plate of the bend-
ing block
(16)
by unscrewing the corresponding hexagon screw
(17).
Thus, the swivel joint
(22)
of the bending blocks is exposed.
For steps 3, 4 and 8 see Figure 2
3.
Attach the spring-forming mounting die
(32)
with two hexagon screws (in position 1).
4.
Set the spring pin
(25)
of the spring-forming die “A”
(31)
in hole 3 and attach the long hexagon
screw
(26)
in position 2.
For steps 5 and 7 see Figure 3
5.
Set the piece to be bent into the hole of die “A”
(31).
6.
Move the bending block unit forward until it touches the workpiece, and secure it in that position.
7.
Bend the workpiece until the piece to be formed has roughly reached the pin (see “P” on figure).
8.
Now set the spring pins
(25)
of the spring-forming die “B”
(30)
into the holes 4 and 5.
9.
Finish bending by completely bending the piece around the dies.
Figure 2
Figure 3