https://www.XPOtool.com
Item 61344
Page 3
The Tool Experts
03 2023-1
Introduction
Thank you for choosing to purchase this quality product. To minimise the risk of injury, we ask you to
always take some basic safety precautions when using this product. Please read this operating manual
carefully and make sure that you understand it.
Keep these operation instructions in a safe place.
Safety instructions
•
Modifications due to technical progress can be made by the manufacturer without advance no-
tice and may not be considered yet in this user’s manual.
•
Before use, check the device for completeness, functionality, and tightness.
•
Never use a damaged or dysfunctional device. Have the device checked by a qualified repair-
man.
•
When performing any work with the device, wear protective equipment such as working gloves,
sturdy shoes, respiratory protection, hearing protection, etc.
•
Make sure that the work zone is always well illuminated and ventilated.
•
Always make sure that parts of your body or clothes cannot get near dangerous zones while
working.
•
Never point the spray gun towards persons, animals, or sources of heat.
•
Avoid any unintentional starting of the trigger when not using the device.
•
Keep children and casual bystanders away from your work zone.
•
Always work with care and the attention required.
•
Never apply excessive force when using the device.
•
Make sure to have a good and safe stand when using the device.
•
Only use pressurised air as pressure source, never use gases such as oxygen as pressure
source.
•
Disconnect the pressurised-air supply when the device is not in use.
•
Never carry the device on its pressurised-air hose.
•
Do not perform work with this product when being tired or influenced by alcohol, drugs, or med-
icine.
•
Only keep packing material (films, plastic bags, polystyrene, etc.) out of children’s, in particular
babies’ reach. Packing material hold dangers that might not be visible.
Danger of suffocation!
Intended use
•
The spray gun with tank is designed for the pulverisation of certain material.
•
The spray gun with tank is
NOT
designed for the pulversation of paint.
Commissioning
•
The device comes pre-assembled except its handle.
•
Screw the side handle to the device.
•
For commissioning the deivce, a pressurised-air compressor is required (not included in the
scope of delivery).
•
Make sure that the compressor is switched off.
•
Fill the tank with spray material and screw the gun onto the tank. The gaskets must be tight.
•
If required, connect the appropriate probe in front of the gun.
•
Connect the pressurised-air hose of your compressor to the pressurised-air connector of the
spray gun.
•
Actuate the trigger to commission the gun.
•
After work, the pressurised-air hose should be disconnected from the gun.