Due to the used enclosure material, the product shall only be connected to a USB
Interface of version 2.0 or higher. The connection to so called power USB is prohibited.
The adapter shall be installed near the equipment and shall be easily accessible.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS
FCC statements:
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: The manufacturer is not responsible for any radio or TV interference caused
by
unauthorized modifications or changes to this equipment. Such modifications or
changes could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed
to provide reasonable protection against harmful interference in a
residential
installation. This equipment generates uses and can radiate radio
frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful
interference to radio communications. However, there is no
guarantee that
interference will not occur in a particular installation. If this
equipment does cause
harmful interference to radio or television reception, which
can be determined by
turning the equipment off and on, the user is encouraged to
try to correct the
interference by one or more of the following measures:
‐ Reorient or relocate the receiving antenna.
‐ Increase the separation between the equipment and receiver.
‐Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
‐Consult the dealer or an experienced radio/TV technician for help.
RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based
on a distance of d=10 mm between the device and the human body. To maintain compliance with RF
exposure requirement, use product that maintain a 10mm distance between the device and human body.
