Xperia 5 IV User Manual Download

Page: 118 / 122

116

FCC RF Exposure Information

Your handset is a radio transmitter and receiver. It is
designed and manufactured not to exceed the emission limits
for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government.
The guidelines are based on standards that were developed
by independent scientific organization through periodic and
thorough evaluation of scientific studies. The standards
include a substantial safety margin designed to assure the
safety of all persons, regardless of age and health.
The exposure standard for wireless handsets employs a unit of
measurement known as the Specific Absorption Rate, or SAR.
The SAR limit set by the FCC is 1.6 W/kg. The tests are
performed in positions and locations (e.g. at the ear and worn
on the body) as required by the FCC for each model.
The highest SAR value as reported to the authorities for this
phone model when tested for use by the ear is 0.58 W/kg,
when worn on the body is 0.63 W/kg and when WiFi hotspot
mode is 0.63 W/kg. For body-worn operation, this phone has
been tested and meets the FCC RF exposure guidelines. Please
use an accessory designated for this product or an accessory
which contains no metal and which positions the handset a
minimum of 1.0 cm from the body. For devices which include
"WiFi hotspot" functionality, SAR measurements for the device
operating in WiFi hotspot mode were taken using a separation
distance of 1.0 cm. When using the device as charger, you
need to put the phone on a flat surface and 20 cm separation
distance from user during the charging mode.
The use of accessories that do not satisfy these requirements
may not comply with FCC RF exposure requirements, and
should be avoided. The FCC has granted an Equipment
Authorization for this model handset with all reported SAR
levels evaluated as in compliance with the FCC RF emission
guidelines. SAR information on this model handset is on
file with the FCC and can be found under the Display Grant
section of

https://www.fcc.gov/oet/ea/

after searching on

FCC ID PY7-17565F.
Additional information on Specific Absorption Rates (SAR) can
be found on the FCC website at

https://www.fcc.gov/general/

radio-frequency-safety-0

FCC Statement for the USA

This device complies with Part 15 of the FCC rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Any change or modification not expressly approved by Sony
may void the user's authority to operate the equipment.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.