Window Kit Component Parts
E
Minimum 30 seconds
Maximum 30 minutes
Installation
In a window glazing unit with a Ø115mm prepared hole at least 110mm in from the edges of
the glazing beads to the centre of the hole. With a maximum thickness of 43mm.
As far away as possible from and opposite to the main source of air replacement to ensure
airflow across the room (e.g. opposite the internal doorway).
Near the source of steam or odours.
Not where ambient temperatures are likely to exceed 50°C.
If installed in a kitchen, fans must not be mounted immediately above a cooker hob,
or eye level grill.
If installing in a room containing a fuel burning device which has a non-balanced flue, it is
the installer's responsibility to ensure that there is enough replacement air to prevent fumes
being drawn down the flue when the fan is operating up to maximum extract.
Refer to Building Regulations for specific requirements.
Exhaust air must not be discharged into a flue used for exhausting of fumes from appliances
supplied with energy other than electric. Requirements of all authorities concerned must be
observed for exhaust air discharge and intake flow rates.
Not suitable for use in possible chemical corrosive atmospheres.
What the installer will need.
No.1 or 2 Pozidrive screwdriver.
Method
Remove backing from gasket, insert window duct through hole and adhere window duct to
window.
ENSURE
slots in window duct face downwards as shown in diagrams.
Insert locator ring into window duct.
Insert the 4 pegs into the appropriate holes in the locator ring to ensure the minimum clearance
between peg and the outside surface of the window.
Gently tighten the 4 x M3 6mm long pan-head clamp screws to clamp the window kit in position.
(
CAUTION
over tightening may shatter the window).
Install fan in window kit in accordance with its installation instructions using the 3 x M4 8mm
long screws provided.
