How It Works
This product is a dehumidifier. It controls relative humidity by passing the air through
the unit, forcing the excess moisture to condensate over the cooling elements.
Contact with this cold surface causes the moisture in the air to condense. This condensed
water then drains safely into the water tank. The dried air then passes through the condenser
where it is slightly warmed and re-enters the room at a slightly elevated temperature.
N.B. As with all compressor type dehumidifiers their effectiveness is reduced the colder
the ambient temperature is. Do not use where the ambient temperature is 5°C or lower.
Water tank
Fan
Compressor
Motor
Evaporator
Condenser
Air Outlet
Air Inlet
1. Before switching on for first time please ensure unit has settled for 12 hours.
2. Please remove ‘carbon filter’ from its bag and locate between the anti- dust filter
and air inlet on the body of the product (make sure carbon filter is lined up properly
with guide locators on the air inlet).
3. Ensure pre filter and carbon filter is fitted securely to the product before switching on.
4. Plug product in.
5. Press on/off button.
6. Select the humidity control button and keep pressing until ‘cont’ lights up- this will
set product to run continuously- leave to 3 minutes then adjust humidity control to
your desired setting.
The lower the setting e.g 40% the product will try and target 40% relative humidity
(ambient humidity) which is for drier conditions. Nearer 70% setting, the product
will try and target 70% relative humidity e.g. more humid/ moist conditions. Unless
this setting is changed, the product will now start controlling the ambient
humidity in the room.
Quick start/ First time operation
7
