V1.0 ©2019 XOTIK
Remove the safety screw and press the lever at the base of the handle to swing open the battery door.
Install the two batteries according the orientation stated inside the battery compartment. After battery
installation, close battery door and tighten safety screw.
Press in the power button on the top of the transmitter. The LED around the power button will glow
after power on. If not, power off the transmitter and re-check the installation of batteries. A flashing
LED means low batteries and needs to be replaced.
IMPORTANT! Always power on the transmitter first and the receiver second. Your transmitter will
automatically link (connect) to your receiver. If you are running two or more receivers at the same time
be sure to power on the receiver one at a time. If not you may link to the wrong transmitter.
RECEIVER SETUP
Mount the receiver as stated in the model’s instructions.
IMPORTANT! Always power on the transmitter first and the receiver second. Your transmitter will
automatically link (connect) to your receiver. If you are running two or more receivers at the same time
be sure to power on the receiver one at a time. If not you may link to the wrong transmitter.
STEERING TRIM CONTROL
The center point of the steering can be finely adjusted as needed to get the best control of the model.
Press either of the two ST TRIM button on the top control panel of the transmitter to adjust the left and
right center trim of the model.
The center position of the steering can be identified when the LED flashes briefly while the left or right
trim is being adjusted.
FAILSAFE
A failsafe function is built into the transmitter system. If the link between the transmitter and receiver is
broken, both steering and throttle will return automatically to the center position. To re-established
normal function, both transmitter and receiver will need to be power cycled (turned off, then turned
back on).
