XT-12P
Installation
Wall Bracket Installation
Dig out a square hole
(height*width*depth=269.5
*122.4*60.5mm).
Note: user need to make
the hole a little bigger
than recommended value
that can accommodate all
cables.
Insert the embedded box
into the hole and make sure
the cables of the door phone
can route through the cable
hole. Then mark the 6 holes
of the wall embedded box on
the wall.
Take down the embedded
box, and then use a hand
drill with 5mm diameter
bit to make holes in the
marked positions.
Insert the screw fixing
seat in the hole you
drilled before.
Place the embedded box into the
square hole
until the edges of
which align to the wall and
make
all cables go through the cable
hole. Fix the embedded box with
6 ST4x20 screws.
Note: The embedded box cannot
over the edge of the square hole.
Use 6 M4x10 screws
to fix the stand on
the embedded box.
Summary of Contents for XT-12P
Page 3: ...XT 12P...
