+ +
++
+
++
+
++
+
BOTTOM OF DOOR
installing the overlay panel
5. Center the panel on the door and clamp it
in place to prevent shifting during attachment.
6. Using the HINGE ANGLE BRACKETS installed
on the door as a guide, drill two holes:
One 3/16” Hole down from the top into the door 1/2” deep.
Remove the plastic bushing from the lower angle bracket.
One 5/16“ Hole up from the bottom into the door 1/2” deep.
Replace the plastic bushing into the lower angle bracket.
This is to accommodate the hinge pins.
7. Taking care not to drill through the panel -
using the holes in the door, drill a 1/8” pilot hole
5/8” deep in each of the four screw holes located
in the corners of the gasket groove (ref: Step 2).
8. Using the four (4) self tapping screws provided
install one screw into each one of the four holes.
9. Drill a 1/8” pilot hole 3/4” deep in each of the three screw holes located in the BLACK support
plate mounted to the bottom of the door into the bottom edge of the panel. Using the three (3)
screws provided (
shown in RED
) secure the panel from the bottom to the support plate.
21
PANEL
DOOR
