7.Install the Halogen lamp.
(2)Rotate
clockwise
(1)Push
in
8.Replace the filters and turn on the power at service panel and test for proper operation.
OPERATION
The hood is operated using a rocker switch on the front panel.
Blower switch
The 3-position blower switch turns the blower ON/OFF and controls the blower speed.
Set the left side of the switch (0) turns blower on and off.
Set the middle of the switch (1) turns blower on to low speed.
Set the right side of the switch (2) turns blower to high speed.
Light switch
The 3-position blower switch turns the lights ON/OFF and controls their intensity.
Set the left side of the switch (0) turns the lights on and off.
Set the middle of the switch (1) turns the lights on to low intensity.
Set the right of the switch (2) turns the lights on to high intensity.
CAUTION- The unit is for General Ventilating Use Only. Do Not Use To Exhaust Hazardous
Or Explosive Materials And Vapors
MAINTENTANCE & CLEAN
Caution: Unplug or disconnect the appliance from the power supply before servicing.
GREASE FILTER
* The grease filters should be cleaned frequently (ever y two months of operation, or
more frequently for heavy use). Use a warm detergent solution.
* Grease filters are washable.
Remove the grease filters from the hood. Wash the filters, taking care not to bend them. Allow
them to be dry before refitting.
When refitting the filters, make sure that the handle is visible from the outside.
Reinstall the grease filters to the hood.
RECIRCULATION CHARCOAL FILTER (FILTERING VERSION)
This charcoal filter is not washable, can not be regenerated, and should be replaced
approximately every 3 months of operation, or more frequently in the case of heavy usage.
HOOD CLEANING
Stainless steel is one of the easiest materials to keep clean. Occasional care will help preserve
its fine appearance.
Cleaning tips:
* Hot water with soap or detergent is all that is usually needed.
* Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to avoid water
marks.
* For discolorations or deposits that persist, use a non-scratching household cleanser or
stainless steel polishing powder with a little water and a soft cloth.
* For stubborn cases use a plastic scouring pad or soft bristle brush together with cleanser and
water. Rub lightly in direction of polishing lines or “grain” of the stainless finish. Avoid using
too much pressure that may mar the surface.
* Do not allow deposits to remain for long periods of time.
* Do not use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface
causing rust.
* Do not allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in
contact with stainless steel for extended periods. Many of these compounds contain
chemicals that may be harmful. Rinse with water after exposure and wipe dry with a clean
cloth.
* Painted surfaces should be cleaned with warm water and mild detergent only.
11
12
FILTER & REPLACEMENT PARTS
Light Bulb: Model: XOPXOE12B (GU10, 120V, 50W Max)
Recirculation Filters: Model: XORFK10 = 30”, Model: XORFK11=36”
Replacement Mesh Filters:
Model: XOPXOE3012F = 30”, Model: XOPXOE3612F=36”
