background image

*The above information appears on the label affixed to the bottom of the disposer.  

For your convinience, write down the model number and serial number prior to installation.

WARNING: 

 

When using electrical appliances, basic safety precautions must always be followed,

 

including:

Read all instructions prior to use.
To reduce the risk of injury, closely supervise children when the appliance is in use.

NEVER

 put hands or fingers into a waste disposer.

Turn off power switch AND unplug power cord

 before attempting to clear a jam or remove an 

object from the disposer.
When attempting to loosen a jam in a waste disposer, use a long wooden object such as the 
handle of a wooden spoon.
When attempting to remove objects from a waste disposer use only long handled tongs or pliers
to avoid reaching in.
To reduce risk of injury by materials that may be expelled by a waste disposer, 

NEVER

 

put:

 

Drain Cleaners, China, Glass, Plastic, Metal, Large Bones, Hot Grease, Hot Liquids or other  
hazardous materials 

into the disposer.

 

When not operating the disposer - leave the stopper in place to reduce the risk of objects falling
into the disposer.

NEVER

 operate the disposer without the splash guard in place.

The disposer 

MUST

 

be

 properly grounded  - see the ELECTRICAL CONNECTION section of this 

manual.
If the supply cord is damaged, it 

MUST be replaced

 by the manufacturer, its service agent, or an 

authorized person in order to avoid hazard.

SINK PRO

NAN

O

GRIND

OPERATING & INSTALLATION

INSTRUCTION MANUAL

BEFORE YOU BEGIN:

Your XO Food Waste Disposer has been designed exclusively for residential use, 
for operation on 120V 60 Hz US household current only  
Any other use will void warranty and may constitute a hazard. 

Read All Instructions Thoroughly Before Installing or Using the Disposer.

Make Certain to Review Instructions Pertaining to RISK, FIRE, ELECTRIC SHOCK
or PERSONAL INJURY Prior to Use.

NOTE:

IMPORTANT:

CAUTION:

RECORD YOUR MODEL # & SERIAL NUMBER HERE:

*MODEL #                                                                                       *SERIAL #

IMPORTANT SAFETY INSTRUCTIONS

2.
3.
4.
5.

6.

7.

8.

9.

10.
11.

12.

www.xoappliance.com

Use this appliance for its intended purpose only as described here in the manual.

1.

Summary of Contents for SINK PRO NANOGRIND XOD1HP













Reviews: