7 /
17
XNET Network Box Camera Installation Manual
2
2
.
.
3
3
.
.
2
2
.
.
F
F
r
r
o
o
n
n
t
t
/
/
R
R
e
e
a
a
r
r
V
V
i
i
e
e
w
w
Figure 2-2 Network Camera Front / Rear view
STATUS LED :
Indicate the status of the product
EVENT LED : If the alarm out is operating, the green LED blinks.
SYSTEM LED : The system operates normally when the blue LED operates.
MIC :
Have built-in microphone.
LINE IN:
Connects to auxiliary Audio Device. 3.5 mm mono/ stereo audio connector is used.
For connection, refer to the figure below:
Figure 2-3. Connector for LINE INPUT and Audio LINE OUT
LINE OUT
: Audio signal output to a Power Amplified device or Speaker. This can be used to listen to
the audio signal sent from a remote PC for Bi-directional Audio communication.
VIDEO OUT
: Use this output to monitor the analog video signal while installing.
(Select Video Out at menu screen to enable this output)
Factory Reset
: Press and hold for more than 3 seconds while power is on to recall factory default
settings
NETWORK
: This Ethernet terminal connects to 10Mbps or 100Mbps LAN through an RJ-45 connector.
When optional PoE is used, the power will be supplied from the Network Cable.
LINE IN(mono)
/MIC IN
GROUND
GROUND
LINE
OUT(mono)
MIC
STATUS LED
Factory
Reset
Power LED