16
Vehicle Installation
Locate a flat surface for the swivel mount on the dashboard .
2
Make sure there is ample room for the car cradle and radio when installed .
Use the alcohol pads in the swivel mount preparation kit to clean the
3
surface . Let it dry thoroughly .
Remove the adhesive liner from the swivel mount .
4
Position the swivel mount where you want it, then press and hold the swivel
5
mount in place for 30 seconds .
IMPORTANT!
Let the adhesive cure for 24 hours before connecting the car cradle
and radio to the swivel mount .
Turn the swivel to accommodate the car cradle and radio . Adjust the
6
tension by turning the center screw .
You can adjust this screw
to adjust the tension of the
mount .
Summary of Contents for XMCK10AP
