AERODYNAMIC ACCESSORIES
TORPEDO KOMPACT
TORPEDO KOMPACT
IMPORTANT:
PLEASE COMPLETELY UNDERSTAND ALL USER INSTRUCTIONS AND SAFETY INFORMATION BEFORE USING THIS PRODUCT. AS WITH ANY HIGH TECH PRODUCT YOU
WILL NEED TO ROUTINELY CHECK FOR LOOSE HARDWARE, CRACKS OR OTHER DAMAGE AND REPLACE ITEMS AS NECESSARY.
DO NOT USE PRODUCT IF ANY OF THESE CONDITIONS EXIST.
The
TORPEDO KOMPACT
comes pre-assembled in the packaging so the only step needed is to adjust the clamp width to fit
your aerobars. The
KOMPACT
comes assembled for bar extensions 85mm - 150mm center-to-center.
For aerobar extensions between 70 and 84mm center-to-center, the rear cage position must be used. See section “Moving the Cage to
the Rear Position” below for those steps. The computer mount is already assembled for Garmin Edge series. For Garmin Multisport
watches see section 3.
1. TO MOUNT THE TORPEDO KOMPACT:
1.
Remove Aqua-Shot bottle
from the cage by pulling directly forward.
2.
Undo the Velcro straps (A)
on both mounting clamps.
3.
Loosen the clamp mounting screws (B)
using the 3mm Hex L-Wrench.
4.
Mount the Torpedo Kompact
on the aerobar extensions by pressing each of the
mounting clamps onto the extensions until they snap into place. There should be
an audible “click” when they snap on. The mount should be positioned as far back
on the aerobars as possible for optimal steering control. The
TORPEDO KOMPACT
will also mount on aerobars that angle inwards as the clamps can rotate to accommodate
the angle.
5.
Center the mount
between the extensions and make sure the bottle is pointed directly forward from the bike.
6.
Tighten the clamp mounting screws (B)
to 35 in lbs (4.0 Nm) of torque.
7.
Secure the Velcro straps (A)
by routing underneath the extensions, up through the slot at the end of the clamp and back
down to attach the Velcro. Ensure the strap is tight enough so that the silicone underneath is firm against the extensions
(See ‘
Strap Routing Diagram
’). Make sure to pull the strap as tight as you can so the mount doesn’t move.
8.
The mount is now secure
and the bottle can be placed back in the cage.
A
B
C
D
E
Strap Routing Diagram
Computer
Mount
Cage
Thin Black
Spacer
Thick Silver
Spacer
Strap
Plate
Clamp
Aerobar
Extension
Strap
MOUNT CLAMPS TO FLAT PLATE
MOUNT CAGE TO FLAT PLATE
COMPUTER MOUNT
M5 x 8mm Button Head
M5 x 18mm Button Head
M5 Nylon Insert Lock Nut
Thick Silver Spacer
M4 x 10mm Flat Head
M3 x 6mm Flat Head
Thin Black Spacer
Hardware
C
F
E
D
G
B
F
Mounting Clamp
TOOL REQUIRED
3mm Hex L-Wrench
Torque Wrench up to 35 in lbs (4.0 Nm)
