XL-SEAT
2004-2009 DODGE DURANGO PASSENGER
p. 3
4-
Install floor adaptor #
XLS-DRGO04R-01
. To do so, lift the back of the seat to allow the
adaptor to slide under the driver’s seat. Use the original floor bolts to position the
adaptor in place. NOTE: Do not fully tighten the floor bolts at this point.
5-
Attach adaptor #
XLS-DRGO04R-03
to adaptor #
XLS-DRGO04R-02
, previously
installed in step 2. Use a 3/8’’x 3/4‘’ bolt. Install the
XL-SEAT
onto the floor adaptor.
Secure the bottom of the
XL-SEAT
with a 3/8’’x 3/4‘’ bolt. Attach the top to adaptor
#
XLS-DRGO04R-03
using two (2) 5/16’’x 3/4‘’ bolts. Secure the motor
to the floor
adaptor using a 1/2
’’x 1 1/4’’ shoulder bolt.
(The pictures may differ from the actual
vehicle.)
6-
Proceed with the installation of the electrical wiring for the XL-SEAT. Follow the
instructions found in the attached document entitled:
ELECTRICAL INSTALLATION FOR
XL-SEAT.
7-
Install the safety guard over the motor. Use a self-tapping screw to hold the guard in
place.
