Xitrix XPN-GX27165QC2, User Manual

Page: 3 / 10

3/10
Keep the device away from rain and humidity to prevent risk of fi re and electrocution. Do not
introduce material (solid or liquid) inside. If this should accidentally occur, disconnect the device from the
mains and have it inspected by quali fi ed personnel.
Never open the device. In all cases, contact the quali fi ed personnel or authorized service
center for repairs.
Keep the device away from children, to prevent accidental damage.
Do not touch the device with wet hands to prevent electrical shock or mechanical
damage.
Do not use the device if it should fall or the external casing is damaged. Risk of
electrocution if the device is used in such conditions. Contact the reseller or your installer.
It is advisable to disconnect the power wire if the monitor is not used for an extended
period.
1.3.3 INSTALLATION PRECAUTIONS
To prevent overheating the device, arrange it in a position allowing the fl ow of air through the
slots in the casing. Ensure at least 5 cm of free space when installing inside a rack. For the same reason,
do not install sources of heat, such as radiators or hot air ducts. Keep away from direct sunlight. Do not
install in areas subject to excessive dust, mechanical vibrations or shocks.
Do not arrange this device on an unstable surface, such as a tottering or slanted table.
The device could fall causing injury or mechanical failures.
Do not install the device in a place where it could be exposed to humidity or water. Do not
direct a jet of water onto the device: risk of fi re, electrocution or mechanical failure.
Stop using the device if water or other material should penetrate inside: risk of fi re and
electrocution. Contact the retailer or authorized installer.
Slots and openings in the cabinet are provided for ventilation. These openings must not be
blocked or covered.
Do not place heavy or heat generating objects on top of the device: this could damage the
casing and/or increase internal temperature causing faults.
Do not cover the device with a cloth while it is running to prevent deforming the external
casing and overheating the internal parts: risk of fi re, electrocution and mechanical failure.
Keep magnets and magnetized objects away from the device to prevent faults.
Do not use the device in the presence of smoke, vapor, humidity, dust or intense vibrations.
Wait for a while before operating a device immediately after transporting it from a cold place to
a warm place and vice versa. Wait on average for three hours: this will allow the device to adapt to the
new ambient temperature and/or humidity, etc.
The monitor is provided with a plastic base and rubber feet. It can be positioned on a horizontal
surface, such as a desk or a table. Make sure that the device is fastened fi rmly and that it is not resting on
unstable supports or surfaces. Dropping could cause severe injury and damage the device.
Remember to adjust the brightness and contrast to obtain a perfect image.
The monitor can also be installed on the wall by means of a bracket (not provided).
1.3.4 CLEANING THE DEVICE
Rub delicately with a dry cloth to remove dust and dirt.
Dip the cloth in neutral detergent if dirt cannot be eliminated with a dry cloth alone.
Do not use volatile liquids (such a petrol, alcohol, solvents, etc.) or chemically treated cloths
to clean the device to prevent deformation, deterioration or scratches to the paint fi nish.
1.3.5 PRIVACY AND COPYRIGHT
The monitor is a device for CCTV systems. Recording of images is subject to the laws in force
in your country. Recording of images protected by copyright is forbidden.
Product users shall be responsible for checking and respecting all local rules and regulations
concerning monitoring and recording video signals. The manufacturer SHALL NOT BE LIABLE for use of
this product not in compliance with the laws in force.