Spartan-6 FPGA GTP Transceiver Wizard v1.8
17
UG546 (v1.8) December 14, 2010
Setting Up the Project
Setting the Project Options
Set the project options using the following steps:
1.
Click
Part
in the option tree.
2.
Select
Spartan6
from the Family list.
3.
Select a Spartan-6 FPGA from the Device list which supports GTP transceivers.
4.
Select an appropriate package from the Package list. This example uses the
XC6SLX45T
device
(see
Note:
If an unsupported silicon family is selected, the Spartan-6 FPGA GTP Transceiver
Wizard remains light grey in the taxonomy tree and cannot be customized. Only Spartan-6 FPGA
devices containing GTPA1_DUAL transceiver primitives are supported by the Wizard. See the
Spartan-6 Family Overview
for a list of devices containing GTPA1_DUAL transceiver primitives.
5.
Click
Generation
in the option tree and select either Verilog or VHDL as the output
language.
6.
Click
OK
.
X-Ref Target - Figure 3-3
Figure 3-3:
Target Architecture Setting
