Xilinx Kintex UltraScale FPGA KCU1250, User Manual

Page: 47 / 80

KCU1250 User Guide www.xilinx.com 47
UG1057 (v1.0) December 19, 2014
Appendix A
Default Jumper Settings
Introduction
Table A-1 lists the jumpers that must be installed on the KCU1250 board for proper
operation. These jumpers must be installed except where specifically noted in this user
guide.
IMPORTANT:
Any jumper not listed in Table A-1 should be left open for normal operation.
Table A-1: Default Jumper Settings
Reference
Designator
Name Board Location
Jumper/Dip-switch
Position
Comments
SW2.1 V
CCINT
Lower left OFF
SW2.2 V
CCBRAM
Lower left OFF
SW2.3 V
CCAUX
Lower left OFF
SW2.4 V
CCO_HP
Lower left OFF
SW2.5 V
CCO_HR
Lower left OFF
J87 MGT PMBUS CTRL Upper left GND (2-3)
J8 MGT PMBUS isolation Center right Installed
J24 V
TT_HP
source Upper left GND (1-2) Red 20A jumper
J25 V
TT_HR
source Lower left GND (1-2) Red 20A jumper
J121 I2C_DUT Center right GND (2-3) Disabled
J125 I2C_SYS Center right Pull-up (1-2) Enabled
Send Feedback