8
KC705 Getting Started Guide
UG913 (v3.0.2) April 23, 2013
Chapter 1:
Getting Started with the Kintex-7 FPGA KC705 Embedded Kit
Video Demonstration Hardware Setup Instructions
This demonstration requires default switch and jumper settings on the KC705 board. For
more information on the default switch settings, refer to the
Hardware Test Board Setup
Requirements
section of
Kintex-7 FPGA KC705 Evaluation Kit Getting Started Guide
(Vivado Design Suite)
. Ensure the following jumper settings for the video demonstration:
•
Jumper 27: Short pins 2 and 3
•
Jumper 28: Short pins 2 and 3
•
Jumper 29: Short pins 1 and 2
•
Jumper 30: Short pins 1 and 2
•
Jumper 32: Short pins 5 and 6
•
Jumper 47: Short pins 1 and 2
•
Jumper 48: Short pins 2 and 3
•
Jumper 69: Short pins 1 and 2
•
Jumper 3: Short pins 1 and 2
•
Jumper 4: Short pins 1 and 2
•
Jumper 43: Short pins 1 and 2
•
Jumper 65: Short pins 1 and 2
•
Jumper 68: Short pins 1 and 2
1.
Connect the KC705 board, HDMI cables, display monitor, Ethernet cable, and USB
cables as shown in
.
X-Ref Target - Figure 1-2
Figure 1-2:
Kintex-7 FPGA Video Demonstration Hardware Setup
POWER
SUPPLY
HDMI_OUT
1080P
UG913_c1_02_051612
Ethernet
UART
KC705 Evaluation
Board
JTAG
