Charging
Switching the button to the Input side, charge nickel AA and AAA batteries
(any combination).
1. Ensure that anode and cathode of a battery are in proper contact with
anode and cathode of the device. Insert batteries into the device in the
direction, shown at the picture.
Installing AA battery
Installing AAA battery
2. Recharge batteries by connecting the Micro USB port of the device to a
5V DC power supply.
3. Slowly flashing LEDs indicates a normal charging process; A constantly
lit LEDs indicates that the battery is fully charged.
In the following table you will find general information about the duration
of recharging. This data can vary depending on temperature and current
state of a battery.
The above-mentioned charging time of a batteries is accounted on the input
voltage of 5V / 1A, from 0% to 100% of charging of batteries. The charging
time depends on a level of remaining charge and an ambient temperature.
If you add another battery to the device (when charging a batteries), a
charging time increases.
It is possible after the battery is completely recharged, if a battery has not
been removed from the device in time, an indicator will light up again and
the device will re-charge it. To determine that a battery is fully charged and
to stop a power supply, the device needs a certain amount of time. This
does not indicate a malfunction of the battery charger or battery.
Status of LED indicators